The spiral rebar forming machine is an automated rebar processing machine capable of straightening, rolling, and cutting spiral rebar into various specifications using a spring mechanism. It primarily rolls 10-22mm round steel bars or creates threads. By setting the inner diameter and pitch, different types of spiral rebar and rebar springs can be customized according to customer requirements.
Automatic Rebar Coiling Machine Usage Instructions: The machine is compatible with industrial 380V/50HZ three-phase power. Always connect the machine after disconnecting the power. The wires are labeled; connect them according to the labels.
1. Disconnect the power when not in use. Do not leave the machine powered on for extended periods without use.
2. Place the machine on a flat surface.
3. Check the hydraulic oil level in the tank every 3 months. If the oil level is low, add No. 68 anti-wear oil (the oil level should be above the cold water circulation copper pipe).
4. Disassemble and clean the filter every 2 months.
Adjust the outer diameter, inner diameter, and pitch of the spiral rebar according to the construction drawings or processing requirements. Two pitch adjusting wheels are located at the hydraulic cylinder cut-off point. The pitch is larger when the pitch adjusting wheel moves outwards, and smaller when it moves inwards. The outer diameter of the pitch adjusting wheel is larger when it moves downwards, and vice versa. Input the number of spiral ribs to be turned into the CNC system and adjust the speed. Input the number of spiral ribs to be processed into the CNC system and press the "Start" button for batch processing.
