(1) Main machine (mechanical forming)
Before turning on, check whether all parts of the electrical appliance are normal. Check whether the die holes of the two rollers are aligned, if they are not aligned, open the gear guard, loosen the six screws on the adjustment plate on the passive gear, and turn the passive roller forward and backward to align the two roller die holes, and tighten the screws. The spacing between the working rollers should be kept between 0.4-0.7mm, if it is too large and too small, the passive roller can be loosened, the bearing is closed and drawn, it is adjusted, and after adjustment, the screw and wire drawing are tightened.
After starting the production of the finished product, check whether the working surface on the double roller is fitted, if there is an error, the big gear guard can be removed, and the screw on the outer ring of the passive roller gear can be loosened to adjust.
(ii) Main machine (hydroforming)
First check whether the electrical working condition is normal, and whether the steering of the roller and hydraulic mercury is forward. Then check whether the die holes of the two rollers are aligned, the spacing between the two rollers should be between 0.4-0.7mm, too large and too small should be adjusted. If the two roller die holes are not aligned, open the gear guard, loosen the six screws of the adjustment disc on the passive gear, turn the alignment forward or reverse, and tighten the screws after alignment. If the distance between the two rollers is large or small, the passive (movable) shaft should be adjusted on the four alignment wires on both sides of the active wheel square, and after everything is normal, the mechanical oil should be added to the reducer. Add hydraulic oil to the hydraulic mercury box. The boot pressure test means that the bottom of the pressure adjustment is 11MPa and the high profile is 13MPa. After everything is normal, it can be started for trial production.
(3) Mixer
If the clutch slips during production, the fixing wire on the three-jaw frame can be loosened to adjust, and the angle of the mixing blade on the twin shaft can be adjusted according to the output to ensure the main engine material.
If you need to add additives (dipping, waterproof), you can add them in the mixer.
(4) Conveyor
During normal operation, it is necessary to ensure that the belt does not misalign, if the belt is not correct, the front and rear roller bearing top wire can be adjusted.
(5) Feeder
First of all, start the machine to adjust the belt looseness, the belt must not be misaligned, and then adjust the size of the gate according to the production volume of the forming machine, so that the supply amount is not more and less.
