Waste Wood Crusher Machine

The waste wood crusher machine is an ideal piece of equipment for the initial stage of wood flour production. It can process wood, branches, forks, and other raw materials into sawdust in a single step. The machine offers low investment, low energy consumption, high productivity, good economic benefits, and ease of use and maintenance. It is a specialized tool for producing materials used in edible fungus cultivation or manufacturing high-density boards, particle boards, and sawdust boards.

Model	Power	Capacity	Rotary	Weight
SL-420	15KW	0.5t/h	2800rpm	130KG
SL-500	22KW	1t/h	2800rpm	180KG
SL-600	30KW	2t/h	2700rpm	260KG
SL-700	37KW	2.5t/h	2600rpm	380KG
SL-800	45KW	3t/h	2400rpm	650KG
SL-1000	75+7.5KW	3.5t/h	2000rpm	1100KG

1. Switch on the power and check whether the steering is correct.

2. When installing and changing the cutter, extend the knife edge 2-4mm from the cutter plate plane, and then tighten the bolt.If the pressure bolt thread buckle is found to be worn out, it should be replaced immediately to prevent slip of the knife disc nut.

3. Change the stretching degree of the knife, must be the same stretching knife length.

Depending on the length of the knife, the particles can not reach the ideal, change the different pore size of the rottweiler.

It is strictly prohibited to put the wood with stones and nails into the machine to avoid damaging the knife and the inner part.

Pay attention to check the hammer bolt, found loose, immediately tighten, hammer and bolt wear seriously, should be replaced.

The sharpening Angle is 28-30& DEg;, is strictly prohibited to grind convex surface, convex surface will cause the steel blade to break off or partially unpeel steel.

Frequently used machines should be checked for lack of bearing butter.Butter should be refilled 3-4 hours, not too much.

1. This machine can be used without changing the power and speed. The Angle of the knife can be sharpened to keep the original straight line 28-30 degrees.

2. To change the particle, it is necessary to change the luo and adjust the knife simultaneously. The hole shall be no less than 14mm (diameter), no more than 20mm (diameter), the length of the knife shall be between 3-6mm, and the gap between the bottom knife plate and the knife shall be no more than 1mm.

3. The machine can pulverize wood with a diameter of less than 3cm-20cm.

1. The bearing should be filled with butter in a timely manner. The bearing should be filled with butter once in 3-4 hours for continuous operation.

2. After using the triangle belt for a period of time, the tightness should be adjusted again and it is advisable to decrease by 6-10mm.

3. Clean the machine every day after work, check whether there are cracks or other problems, and repair the machine in time.

Hot Tags: waste wood crusher machine, China waste wood crusher machine manufacturers, suppliers, Double Shaft Machine, Dry Ice Particles Machine, Rotary Charcoal Tablet Press Machine, Wood Cutting Vertical Band Saw Machine, Wood Drum Chipper, Metal Steel Scrap Shredder